Imperial Porter
This full-bodied dark, malty Imperial Porter is a truly satisfying beer with caramel and cocoa sweetness balanced by a medium hop bitterness. Optional: add 100g of Simcoe dry hop for a resinous hop aroma. Brew to 23L; 6.6% ABV; Colour, black, 98 EBC; Bitterness, medium, 27 IBU.
Cost: 35
Equipment
- 1 30 litre fermenter
- 1 Large mixing spoon
- 1 5 litre jug
- 1 Cup
Materials
- 1.8 kg Brick Road Craft Imperial Porter kit
- 1.5 kg Brick Road Dark Malt
- 1 kg Brick Road Dark DME
- 100 g Simcoe hops Optional
Instructions
- Clean and sanitise fermenter, spoon, cup and jug.
- Fill the cup to 3/4 full with cold brewing water. Sprinkle in the dried yeast and gently stir in. Cover.
- Soften the malt cans in hot water for about 5 minutes.
- Pour 2 litres of boiling water into your 5L jug. Open the cans and pour the contents into the jug.
- Mix the concentrated wort and water well, then pour into your fermenter. Top up with cold quality brewing water to 23L for approx. 4.3% ABV. Stir in the DME. Vigourously stir the wort with a large spoon to oxygenate it. Ensure the wort temperature is 16-25 degrees Celcius. Gently pour in the cup of yeast slurry and gently stir into the oxygenated wort.
- Seal the fermenter lid and insert airlock. Ideally ferment at 18-24 degrees Celcius for 10 - 14 days.
- Dry hop at 5 days. Ideally add the hope to a hop bag and immerse in the wort. remove after 48 hours.
- After 10-14 days, check the gravity. If the SG remains steady for three days, fermentation is complete. If in doubt, leave a few more days for better results. Keg or bottle your brew.
- NOTE: For WilliamsWarn and pressure brewing systems, follow the fermenting instructions for an Ale yeast recipe.
